UniPrint109 and UniPrint116 HSLA Support - Innovative Machine, Inc.

The UniPrint109 and UniPrint116 HSLA models are side apply machines. The difference between the two models are the main board (blue vs red), the addition of the regulator, and the upgrade from the Norgren Valve to the MAC Valve.

This page will provide support with documentation, videos, and replacement parts for both the UniPrint109 and UniPrint116 models.

Would you like IMI to repair your Machine?

If you would like IMI to repair your machine, click here to view the process.

Documentation

UniPrint116 Operator Manual

UniPrint116 HSLA Wiring Diagram

S84-ex Operator Manual

S84NX Operator Manual

Support QR Codes for UniPrint Models

HSLA RFID Recommended Spare Parts

HSLA Inspection Checklist

Videos

The videos below give instruction on tasks necessary to maintain/operate Innovative Machine equipment.

HSLA Machine

The following videos will cover:
HSLA Overview
Loading labels on a HSLA
HSLA setup prior to production
UniPrint116 HSLA – Cleaning
UniPrint116 – SKB Shipping Crate
M8485 to S84 Conversion

HSLA Overview
Loading labels on a HSLA
HSLA setup prior to production
UniPrint116 HSLA – Cleaning
UniPrint116 – SKB Shipping Crate
M8485 to S84 Conversion

Part Replacement

Each video below is demonstrated on either a HSLA or SSHSLA model, but the steps/procedures will be the same for all UniPrint models:
Print Engine Removal/Replacement
UniPrint116 – Air Assist Rod Replacement
UniPrint116 – Air Valve Replacement
UniPrint116 – Air Tubing Replacement
Regulator Replacement
Take Up Motor Replacement
Low Label Sensor Replacement
On/Off Switch Replacement and Testing

Print Engine Removal/Replacement
UniPrint116 – Air Assist Rod Replacement
UniPrint116 – Air Valve Replacement
UniPrint116 – Air Tubing Replacement
Regulator Replacement
Take Up Motor Replacement
Low Label Sensor Replacement
On/Off Switch Replacement and Testing

S84-ex Print Engine

Each video below is demonstrated on either a Left Hand or Right Hand S84 Print Engine, but the steps/procedures will be the same for both models:
Label Offset
S84 Gap Sensor Calibration
Life and Head Count
Installing a Stage 1 Kit in a S84 Print Engine
Installing a Stage 2 Kit in a S84 Print Engine
Using an EXT DB-25 Tester on a S84 Print Engine
Tracking Collar Replacement
RFID Tuning Insert

Label Offset
S84 Gap Sensor Calibration
Life and Head Count
Installing a Stage 1 Kit in a S84 Print Engine
Installing a Stage 2 Kit in a S84 Print Engine
Using an EXT DB-25 Tester on a S84 Print Engine
Tracking Collar Replacement
RFID Tuning Insert

S84NX Print Engine

Each video below is demonstrated on either a Left Hand or Right Hand S84 Print Engine, but the steps/procedures will be the same for both models:
S84NX – Life and Head Count
S84NX – Offset Adjustment
S84NX – Stage 1 Kit
S84NX – Stage 2 Kit
S84NX – Gap and I-Mark Calibration

S84NX – Life and Head Count
S84NX – Offset Adjustment
S84NX – Stage 1 Kit
S84NX – Stage 2 Kit
S84NX – Gap and I-Mark Calibration

Replacement Parts

HSLA Machine

The following photos display the UniPrint116 HSLA model. If a part is specific to a certain model (UniPrint109 or UniPrint116), the textbox will note both options and part numbers if applicable.

Hover over the teal dots to view spare parts and part numbers for the machine.